Product includes simple application instructions. Only
apply the sticker to a clean and dry surface. The stickers are waterproof,
but will be damaged by abrasion or solvents. They can be used in the
shower or outdoors. They can be used on a vehicle, but there is no
guarantee for this application. If being used on a vehicle, they should be
coated with a clear, water based coating. Please do not place a sticker
within reach of a young child's crib or bed.
APPLICATION INSTRUCTIONS
Lay sticker face down and pull the liner off the sticker part way- about 8
inches. Fold the liner back on itself so the exposed back of the sticker
can be applied to the wall. Remove entire backing on small stickers. Be
careful not to bend or kink the sticker. Do not allow the adhesive on
the back of the sticker to contact any other area on the back of the
sticker! Stickers may stretch or tear if you try to remove the backing
too quickly. After backing is removed, press exposed sticker to surface.
Slowly pull the backing off the sticker and push the sticker on the wall
as you pull the backing. Finish by softly rubbing the entire sticker with
a soft cloth, making sure to include all edges. If, after completion, you
are unhappy with the positioning, simply remove and stick again. If the
sticker does not stick well or curls at the edges, follow the instructions
below. If there are air bubbles, take a pin and poke a hole through the
bubble and press. If you find the sticker pulls off the paint, you can
release the sticker by squirting lighter fluid on the wall above the
sticker. The lighter fluid will run down the wall and soften the adhesive.
The lighter fluid will evaporate off the wall in a few minutes. Once the
sticker is off, lay it face down for a few minutes and let the lighter
fluid evaporate. You can then re-apply the sticker.
TO APPLY TO ROUGH OR GLOSSY
SURFACES:
The stickers work best on flat walls with clean, dry flat paint. They will
work on other surfaces with varying degrees of success. When you get your
order, try a small sticker. If it doesn't stick well, there is a product
that can be used to increase the adhesion. This product creates a stronger
bond. You can get it at Staples or other office supply stores. It is made
by 3M and it is called Super77. Put the sticker on the wall. Spray some
adhesive into a paper cup. Using a small 1/2” brush, lift the edge of the
sticker off the wall and paint the adhesive on the back of the sticker.
Push the edge back on the wall. The sticker will stick within a few
minutes as the adhesive dries. Be careful not to get Super77 on the face
of the sticker. Lighter fluid can be used to clean excess glue, but may
damage the sticker. If the walls are very glossy, you can try using
Hi-Strength 90 by 3M.
TO CLEAN STICKERS:
Use soapy water and a soft towel. Please do not use abrasives or harsh
cleaners or solvents.
WARRANTY
We take pride in our products. In the event that a product is defective in
material or workmanship, liability is limited to the replacement of the
same product.
RETURNS
Returns must be made within 30 days of receipt. Returns must be unused,
undamaged and in saleable condition. Acceptable returns subject to 20%
return charge. Just ship them back to us following the instructions on the
yellow return sheet included with your order OR
Click here
for printable copy